Microtek ArtixScan 4500t Specifications download pdf (Page 17)

ArtixScan 4500t Installation and Operation Manual 13

English

How to use your scanner transparency accessories

There are three ways to scan transparent films:

• By using the Glass Holder, which is used to scan non-standard-sized transparent film.

• By using the Main Holder which is used together with the individual film mount to scan

a particular type of standard-sized transparent film, such as individual

4" x 5", 6 x 6 cm, 6 x 7 cm, or 35 mm film mount.

• By using the 4-in-1 35 mm Slide Holder, which is used together with 4-in-1 35 mm slide

mount.

Step 1: Placing the transparent film

For non-standard-sized transparent film

Using the Glass Holder

ABC

1 Place film on the Glass Holder

(on the surface that prints

“This Side Up”), with the film

upright and facing up.

2 Use the Vinyl strips to tape the

film to the glass to secure it in

place.

ImportantImportant

Important: Make sure the film

is taped securely to the glass.

Otherwise, the film may fall

out when you insert the Glass

Holder into the scanner, and

you will not be able to retrieve

the film.

NoteNote

Note: For best results, the area around the film should be covered so that no light

can go through the glass around the sides of the film.

• The maximum scanning area is 3.8" x 4.8", so trim a piece of black paper to 3.8" x

4.8".

• Cut out a hole in the paper and make the cutout big enough so that the film

underneath shows through. The black paper should then cover the perimeter of

This Side Up

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

No comments

Microtek ArtixScan 4500t Specifications Page 17