4-14 Microtek ScanWizard 5
Attach Output Image to an E-mail
You need the E-mail button to attach the output image to your e-mail. If the
button is currently set at E-mail, click button and the Save As dialog box
displays.
Otherwise, hold pointer on the button for about two seconds or until the
selection menu appears (see top-left figure in previous page). Then select
E-
mail from the menu.
The button immediately
turns into
E-mail button
while the
Save AS dialog
box immediately displays
with the application check
box enabled by default.
Click to select from the
combo box which e-mail
processor you are going to
use (see figure at right).
'E-mail' is the e-mail editor (Netscape Messenger, Microsoft Outlook, etc.) you
have previously installed in your host. If none is installed, only
'Internet Mail'
will be available from the combo box. See Appendix A for proper e-mail editor
installation and setup to ensure compatibility with ScanWizard 5.
'Internet Mail' is the Microtek provided e-mail processor embedded in the
ScanWizard 5.
Click the
Save button to execute final scanning, saving output image to file,
and launching of your e-mail application with the output image attached.
Comments to this Manuals