Microtek ScanMaker 5 User's Guide download pdf (Page 36)

4-4 Microtek ScanWizard 5

Plotting a New Scan Frame

You can always create another scan frame over

an existing one or at another location of the

same preview image. Like your previous scan

frame, point at any corner of your intended

new selection. When the crosshair pointer

appears, drag diagonally until you have the new

desired image selection enclosed in a frame.

When you release the mouse button, the

previous scan frame is discarded.

Magnifying Your Preview Image

SW 5-Standard allows magnification of your preview image to as much as four

times (4x) the size of your original. The zoom scale bar (located at the right side

of your preview image) is provided to easily accomplish zooming of your

preview image. To magnify image, click toward the top (or the plus [+] button)

of the bar, image is zoomed up to an increment of 100% to the maximum of

400%. To shrink image, click toward the bottom (or minus [-] button) of the

bar, image is zoomed down at same increment, to its original size as minimum.

Viewing Hidden Areas of Magnified Image

When the magnified image becomes too large to be accommodated within the

preview window, click and hold on the Pane tool (see right figure above). A

panning frame occurs displaying a miniaturized replica of the whole original

image. Start panning the pane pointer toward the direction of the hidden area

in the miniaturized image. Observe the live or realtime effect in the preview

window which synchronizes the exposures of the hidden area .

Drag crosshair pointer

to plot a new scan

frame selection.

(Previous selection is

discarded.)

Previous selection or

existing scan frame

To magnify image, click on plus

(+) button or on higher scales

To shrink image, click

on minus (+) button or

on lower scales

To view hidden area of

magnified image,

click Pane tool (left).

When panning frame

occurs, drag pane

pointer (right) toward

hidden area of image

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 221 222

Comments to this Manuals

No comments

Microtek ScanMaker 5 User's Guide Page 36

Comments to this Manuals