Microtek ScanMaker 5 User's Guide download pdf (Page 177)

The Scanner Test Utility B-3

4 The Scanner Check button acts as a Scanner probe to verify the location of

your scanner and the scanner ID.

When you click on the Scanner check button, the dialog box below

appears, with the scanner and its corresponding Scanner ID displayed in

the correct location. If your scanner does not appear, the connection

between your scanner and PC may not be secure, causing the system not to

“see” the scanner. In this case, check all cables and make sure your scanner

is ready. You may also want to turn the scanner and computer off, wait for 5

seconds, then turn them on again to reset everything.

5 The Reconfigure Equipment button allows the system to update its own

internal reference file and is used if you have changed your setup or

reconfigured your system.

For instance, if you changed scanner models on your system (physically

removed a scanner model and attached a different one), the Scanner model

box (#1) will not show the change automatically unless you first click on

the Reconfigure Equipment button to update the system. Use this feature to

make quick updates; all changes are done internally and automatically.

Your scanner as verified by Scanner

check

Click OK to close the dialog box

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 221 222

No comments

Microtek ScanMaker 5 User's Guide Page 177