Microtek ArtixScanDI 2020 Plus User Manual download pdf (Page 44)

44 ArtixScan DI 4020 Plus/ArtixScan DI 2020 Plus User's Manual

Maintenance

The separation pad assembly and the feed-roller assembly in your Automatic

Document Feeder (ADF) are designed to make document feeding smooth. After

usage for a period of time, the separation pad assembly and feed-roller assembly

may become worn, and a problem such as document double-feed may occur. In

this case, check either the separation pad assembly or the feed-roller assembly,

and replace them if needed. Follow the procedure below for replacement of the

separation pad assembly and feed-roller assembly.

Replacing the Separation Pad Assembly

1. Push the button at the top of the

ADF, then move the cover of the

ADF up to see the separation pad

assembly, as indicated in the

graphic below.

2. With the cover fully opened, use

your fingers to nip off the

separation pad assembly and pull

it out from its compartment.

3. Insert (as shown in “a”) and

push down (as shown in “b”)

the new separation pad assembly

into its compartment, making

sure that the separation pad

assembly snaps into place.

4. Close the cover.

Note:

• A grey separation pad assembly comes installed with the ArtixScan DI 4020

Plus/2020 Plus for use with scanning paper that weighs from 10 to 30 lbs.

An additional grey separation pad assembly also comes with your scanner

package for replacement.

• The recommended replacement point for the two separation pad assemblies is

approximately 30,000 sheets.

• Please contact your local resellers for purchasing new separation pad

assembly for replacement.

1 2 ... 39 40 41 42 43 44 45 46 47 48

No comments

Microtek ArtixScanDI 2020 Plus User Manual Page 44