Microtek ArtixScan 4000tf Specifications download pdf (Page 26)

ArtixScan 4000tf Installation and Operation Manual 23

Step 2: Align target registration marks

After the upper left mark is aligned,

the upper right part of the target

image is displayed, and an

instruction dialog box will prompt

you to align the upper right

registration mark.

Move the cursor into the target

image area; the pointer will change

to a normal L mark (“ ”). Align the

cursor with the small upper-right

registration mark.

A. Upper-left registration mark

B. Upper-right registration mark C. Bottom-right registration mark

Move the cursor into the target

image area; the pointer will change

to a horizontally flipped L mark

(“ ”). Align the cursor with the

small upper-left registration mark.

After the upper right mark is aligned,

the lower right part of the target

image is displayed, and an

instruction dialog box prompts you to

align the bottom-right registration

mark.

Move the cursor into the target

image area; the pointer will change

to a vertically flipped L mark (“ ”).

Align the cursor with the small

bottom-right registration mark.

Step 3: Create profile

Click on the “Create Profile” button to create a scanner ICC profile. A dialog box will

appear at the end of the profiling process. Enter filename and profile description as

appropriate.

Note

: If the process fails, you will need to rescan the target image and repeat the calibration

procedure. Make sure the registration marks are aligned properly, then click on the Create Profile

button again to create your scanner profile.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

No comments

Microtek ArtixScan 4000tf Specifications Page 26