8
Cautions when replacing PCBs 2 (Printer Section)
Initial setup-----B, G, R-AOM driver
--1-1Laser control PCB
Paper Sensor Adjustment-11-1Printer control PCB
SVBJOthersDPCB
D:DIP switch setting
J:Confirming the connector for the jumper (Set it as same as before
replacing).
S:Reading the System program.
B: Reading the backup data
V:Necessary to adjust the potentiometer
1:Execute
-:Not execute
33_7
7061
Note
• The PCBs mentioned in the Slide are the PCBs that need to be replaced with care.
Comments to this Manuals