NCE mode
QSS-30-3
1 dot
Light
amount
Perfect waveform
Laser beam
It is possible to control the output of laser and correct the color (Cyan, Yellow, etc.)
around the letter by inputting the correction value in the “NCE” mode.
(e.g.)
Outline characters on the black background
The part around black letter on the white background
However, the trend of color changes depending on various conditions (Font type, Font
size, condition of processing solution, etc.). So, even if you make a perfect correction
to a condition, the same quality cannot be gotten for the other conditions.
Description********************************
Light amount of laser is not constant in one dot, not like the ideal
waveform (illustration). The light amount is maximum at the center,
and it is getting smaller gradually as it is close toward the radial
rake.
Therefore, the low density part appears on the half-tone dot meshing
part (illustration), and this part may be colored Cyan, Yellow, etc.
depending on the chromogenic property of paper.
It is not noticeable in the consecutive color. But, it is noticeable in
the following scene.
The scene that the density difference appears clearly, especially
outline characters on the black ground, black letter around the white
background.
Comments to this Manuals