Microtek ScanMaker V6USL User Manual download pdf (Page 6)

3. Connect scanner

Connect one end of the USB cable to your

computer, and connect the other end of the cable to

the USB port on the scanner.

2. Connect power

Connect the power adapter to your scanner, and

plug the other end into a wall outlet or power

source. This will turn on the scanner, and the green

light on the front of the scanner will blink for a few

seconds and then stay on solid. Make sure no

other cable is connected to the scanner except

the power adapter at this point.

1. Unpack scanner

Open your scanner package and check the

components as stated in your packing list. Do not

install any of the software until the hardware has

been installed. Before proceeding any further, check

that you have the items listed on the packing list. If

any item is missing, call Customer Service at 800-

654-4160.

Your Microtek ScanMaker V6

USL comes with two

built-in interfaces: SCSI and USB. See the graphic

below to locate the different ports on the back of

the scanner, including the scanner accessory port.

USB Installation on the Macintosh

SCSI

Port 1

SCSI

Port 2

Accessory

Port

USB

Port

SCSI

ID Dial

Power

Adapter

A. Connecting to an Apple iMac

Power adapter

1 2 3 4 5 6 7 8

No comments

Microtek ScanMaker V6USL User Manual Page 6